Kia K4: Driveshaft and Axle

Contents:

Specification ➤

Special Service Tools

Special Service Tool
Tool Name / Number
Illustration
Description
Ball joint puller
09568 - 1S100

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of tie rod end and lower arm ball joint
CV joint puller
09517 - 4E000

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of CV joint
Band installer
0K495 - C5000

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for installing of ear type boot band

Band installer
0K495 - 2W001

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for installing hook type boot band (low profile)
Band installer
09495 - 39100

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for installing hook type boot band

Troubleshooting

Troubleshooting
Symptom
Suspected causes
Correction
Vehicle pulls to one side
Defect on front suspension and steering gear.
Adjust or replace
Poor installation of the brake disc and brake pad
Replacement
Seized wheel bearing
Replacement
Inappropriated tire air pressure
Adjustment
Unbalanced wear of tires
Adjust the wheel alignment or replace the tire
Inappropriated wheel balance
Adjust or replace
Abnormal wheel alignment
Adjustment
Vibration
Over abrasion, separation, damaged or bended on driveshaft
Replacement
(Replacement using repair kit)
Wheel bearing excessive play
Replacement
Shimmy
Inappropriated wheel balance
Adjust or replace
Defect on front suspension and steering gear.
Adjust or replace
Noise
Excessive worn, damaged, or bended driveshaft
Replacement
(Replacement using repair kit)
Noise on connecting part of driveshaft and hub while driving straight, back or curve (Clicking or Creaking noise)
Tighten hub nuts
or inner washer replacemnt
Noise from inner side of shaft while driving curve (Repeated tapping noise)
Replacement
(Replacement using repair kit)
Friction noise on driveshaft boots (Sticky noise)
Clean and apply fluorine lubricant
Loosen hub nut
Adjust
Defect on front suspension and steering gear.
Adjust or replace
Loosen disc screw
Adjustment
Noise on wheel bearing while driving (Whir noise)
Replacement
Wheel bearing has excessive play, contacted surface of flange burnt
Replacement
Leakage
Leakage of grease on driveshaft boots (partial parts replacement when inboard side boots has leakage)
Replacement
(Replacement using repair kit)
Rust
Corrosion on nonpainting area (Not a problem for functioning)
Explain to the customer it is normal
ABS warning lamp illuminated
Loosen wheel bearing sensor and sensor cable
Adjustment
Contaminated wheel bearing sensor connector
Cleaning
Communication error (Diagnosis using KDS)
Adjustment

Front Axle Assembly ➤

Front Driveshaft Assembly ➤

Rear Axle Assembly ➤

Other information:

Kia K4 (CL4) 2025-2026 Service Manual: Shift lock system

For your protection, the Kia K4 is equipped with a shift lock system. This safety mechanism is designed to prevent the transmission from being shifted out of P (Park) and into R (Reverse) or D (Drive) unless the brake pedal is firmly engaged. To safely shift your Kia K4 from P (Park): Engage and hold the brake pedal firmly. Ensure the ignition is in the ON position.

Kia K4 (CL4) 2025-2026 Service Manual: Fuses

Fuse types in the Kia K4 electrical system Figure 1. Blade type Figure 2. Cartridge type Figure 3.

Contents

Categories

Copyright © 2026 Kia K4 Manuals � 0.0143